NEW AUTOSTICK FLEX HOSES
ALL 3 HOSES WITH NEW METRIC FITTING-NOT ORIGINAL TYPE
PLEASE MEASURE YOUR HOSES FROM FITTING TO FITTING FOR CORRECT LENGTH
3000 PSI PARKER HOSE
SOMEDAY I'LL FIND A SOURCE TO REUSE THE ORIGINAL FITTING
THESE SHOULD LAST A GOOD 20 YEARS PLUS
15.00 SHIPPING IN THE US
Hi
re-usable hydraulic hose fittings [probably a thing of the past now]
You could get the outer part to fit most hose types so if You had a hose to fit the ATF Fittings
then the outers would clamp the hose onto the fitting.
with the introduction of pressed hose fittings and most likely only using common hose sizes
finding these would be very difficult nowadays.
I did Mine 14 years ago..
cheers
LEE
Do you still have to use the washers with the newer fittings?
Quote from: blue_ghia on 24 August 2012, 19:05
Do you still have to use the washers with the newer fittings?
Hi
it all depends on where the holes in the banjo fittings are when You do them up..
the ATF needs to flow smoothly thru the banjo BOLT hole thru the hose fitting hole
if the washers are not correct [too thick or too thin] then the flow is restricted..
it all has to flow exactly right....
the original washers are aluminium alloy .. but copper or brass etc would all be OK
so long as they fit and they don't leak....
LEE in Australia
LOWERED TO 200.00 FOR THE SET
YES YOU HAVE TO STILL USE THE WASHERS-BEEN BUSY SO HAVE NOT SOURCED THEM
I HAVE FOUND SOME ORGINAL SIZED HOSE, BUT IT'S COST IS WOW