Well
hows this for the start of a New year...
Engine and gearbox removed....
I should have the replacement gearbox installed shortly...
I'm going to take the heads off the engine
and replace all the push rod tubes and seals...
I did have a slow leak when the engine was going...
it may have been the top of a pushrod tube seal leaking...
one push rod tube seal was nearly cut in half at the top by the tube itself
the seal wasn't in the correct position when the head was installed..
Lee
Hiya Lee,
I like that removable rear apron. Very nice when it comes to engine pulling!
The car is in the same position as when I took the engine and gearbox out
it could have been closer to the ground...
but I would have trouble crawling under it...
I've also found that You do get tired of yellow and red.. lol...
I hope i never get tired of Gray ... lol...
Lee
Well,
I've bought more gray paint
and some High Temp red paint for the engine tinware...
so, hopefully no more burnt paint..
Lee
http://community.webshots.com/user/vw68autobug
Hi
I'll have to be more vigilant when assembling engines..
I never actually found out if the gearbox was working OK
due to the engine leaking oil between the cylinder and head on 1 & 2
I've also found some weeping of engine oil out the bottom of the gearbox inspection hole...
Lee
Great News...
I'm back on the road
did about 60kms today...
no leaks [fingers crossed]
YIPPEE
Lee